This Week in BlogTalkRadio, 11/30-12/6

With Thanksgiving behind us and Christmas and Hanukah up ahead, it’s been a lively week ...

Partying with Cosby on BlogTalkRadio

Have you heard about Bill Cosby’s LISTENing parties? The New York Times just reviewed ...

Celebrating ‘The Twilight Saga: New Moon’

In honor of the opening day of New Moon, the latest film in The Twilight Saga, we thought we ...

 

Profile

zenghui


Country: Australia

Language: English


Archived Blog Posts

zenghui  

This user has not entered a description yet.

  • Archived Blog Post

    Date / Time:

    Notebook computer system to enable quick access to dormant state of a simple method is to directly c

    To show the battery is damaged. Therefore, the battery maintenance and rehabilitation needs of laptop users is the topic of concern. Maintenance process is also often referred to as "activation", "activation", a very vivid and to reflect that the battery "dead" and rebirth process.I summed up the activation of a battery approach, its basic principle is that when the charge and Gateway m320 battery discharge currents must be small (but not too small, or too long), there is to try to be filled, put completely. Cell damage because the battery in use after a period of time will "aging" of. Concrete expression of the resistance is bigger, at charging time at both ends of voltage rise faster, so it will be easily found for the charge control circuit has been filled, the capacity also is naturally "down". Since relatively large battery internal resistance, discharge voltage drop by high speed, the system can easily mistaken for a voltage not enough, lack of electricity (in fact, there is no electrical discharge).
    As can be seen from the above description of the battery is a vicious cycle of aging process, the discovery of lost working hours, the battery faster than when what it should be tempered, or else it will be finished sooner or later. In addition, many lithium battery failure is the battery package of a certain energy-saving result of core failure, a bad pot of soup mouse droppings. This phenomenon can not be avoided, because the battery power-saving core of each character can not be fully consistent with a long time there are some quality, the aging first weakened, undermining the whole (series after) the discharge curve. It simply means that section of bad batteries before charging full discharge also finished first place, but this time the capacity of the other batteries have not been fully utilized.
    Electric-discharge of lithium, or always-on, let the natural discharge better. Is best not to use physical methods (string of resistors in the class). Not to say that that was not feasible, but relatively large risk, if the internal protection circuit was not working, then set aside the batteries, and the worst is probably the battery explosion, of course, this unlikely. Circuit hidden dangerous is not impossible, a number of big-name manufacturers have found that the design of potential risk factors exist in a battery recall, as mobile phone battery when you do not hear the explosion.
    The core of a power-saving over charge over-discharge will not cause the battery monitoring circuit that the whole is full of / discharge end of the. For example, when charging other batteries start getting close to full charge when pressed, that section of bad batteries may have reached the terminal voltage of 4.30V or higher, resulting in overcharge damage, while others are sufficient dissatisfaction. Editor's note: For internal batteries battery damage, the "Chinese computer education" 2001 No. 2 has a very good article - "notebook computer batteries DIY" worth learning from. Interest, courage and capacity of friends can try to open the battery pack, believe that the help of multimeter, you can quickly find the damaged batteries (voltage abnormality). If conditions permit, according to the corresponding parameters of the Gateway m325 battery replacement batteries can be qualified product. The battery charge and discharge lithium-ion battery charging poses as a way of fast charge constant current in the voltage reaches a certain value and then to slow charging constant voltage mode. Notebook computers are often not strictly a constant-current charge of monitoring devices.
    Small knowledge:In general, notebook computer battery protection circuit in the part is usually voltage block, control chip, insurance, and temperature probes. Temperature protection device is usually a one-off, the inside has a fuse (some 130 ℃ Fuse), is used to monitor the voltage regulator block work. If the charge-discharge process exceptions, immediately there will be a current through the temperature protection device, will fuse fuse, the battery's internal circuitry at this time for the open circuit state, and can not be restored. If you want to repair only the replacement of temperature protection device, but such temperature protection device on the market hard to find. Discharge is the discharge current as small as possible, the operation is to slow down and let the CPU, hard disk stops turn, transferred the darkest the screen (or close the switch off), then do not run any programs until the laptop automatically shut down. The emphasis on small-current discharge is to prevent premature detection of laptop battery shortage. I have disabled the hard disk, close the screen, cancel the power of the state police under the laptop completely discharge (put a close to 6 hours), the battery capacity from 31.72Wh restored to 33.65Wh.
    If you use nickel-metal hydride batteries, which must control the charge time, should be careful not to frequent over-charging, otherwise it will shorten the battery life. In addition, the Ni-MH battery should be fully discharged before charging, the charging should also be fully charged, and in normal use before, but also required to complete three complete charge and discharge times.
    Most users accustomed to using a laptop computer each time, plug the AC power supply, very little battery power for laptops. In fact, for at least a month should be used to power batteries once or twice, the battery Hp 500 battery completely run out, draw a line on a one-time full of alternating current. Remember this one, for rechargeable batteries will run out of power again full, useful and harmless, because the notebook computer lithium-ion batteries for use there is a certain inertia effect for a long time not to use lithium-ion loss of activity would need to re-activation. When the notebook computer when the indoor use of AC is best to remove the battery so that it always in charge state. The best off charging laptop, the battery can be fully charged, do not unplug the power in the charge half-way. Charging is completed, should be 30 minutes before use.

Comments

There are no comments at this time.

Everything Else

Listen

 

Participate

 

Services and Terms

 

Corporate

 

BlogTalkRadio

 

© 2009 BlogTalkRadio.com. All Rights Reserved.